25
1. Make sure your CASSIOPEIA is turned off.
• Press the [Power] button to turn off power.
2. Pressing upward at the point indicated in the illustration, slide the cover up to open it.
3. If there is already a card in the slot, remove it.
4. Slide the card you want to use into the card slot.
• Make sure the top of the card is facing towards the top of the CASSIOPEIA unit. A
card that is not oriented correctly will not slide all the way into the slot.
Carefully slide the card into the slot as far as it will go.
5. Close the card slot cover.
Removing the Card Slot Cover
Remove the card slot cover when using a card that protrudes from the slot when fully
inserted. To remove the cover, pull it up part way open, and then slide it from the unit as
shown in the illustration below.
Replacing the Card Slot Cover
Reverse the above removal operation to replace the card slot cover.
Important
Pull the cover out as far as it will
go and then swing it open.
Press upward here.
Bottom
Top
Important
Handle the cover carefully
and do not force it! Using
too much force can cause
the cover hooks to break
off!
To Next Page
Loading...
Need help?
General