Configuring Settings
EN-14
(2) To input a pitch value, use the [0] (E4) through [9]
(C{5) keyboard keys to input an integer that
specifies the frequency (Hz) of the A4 note.
• For example, to specify a frequency of 442 Hz,
press keyboard keys in the following sequence:
[4] (A}4) 3 [4] (A}4) 3 [2] (F{4). Inputting the
third and final digit will cause a short and then long
beep to sound, indicating that the value you input
was applied.
• You can specify a value in the range of 416
through 465 Hz.
(3) To fine tune by 0.1 Hz increments, press the TUNE–
keyboard key (G5) to lower the pitch by 0.1 Hz or the
TUNE+ keyboard key (A}5) to raise the pitch by
0.1 Hz.
• Each press of the keyboard key causes a beep to
sound. The beep becomes higher whenever a key
operation causes the setting value to become an
integer.
• You can specify a value in the range of 415.5
through 465.9 Hz.
• To return to the initial default setting, hold down
the keyboard TUNE– (G5) and TUNE+ (A}5) keys
at the same time until a long beep sounds.
2.
Release 3 FUNCTION.
You can use the 3 FUNCTION button operation below to
toggle the beep tone between enabled and disabled.
1.
While holding down 3 FUNCTION, press the
B7 (Beep) keyboard key.
• Each press of the B7 keyboard key will cause a short
beep to sound. A low beep sounds when the key
operation disables the beep, while a high beep sounds
when the key operation enables the beep.
2.
After the setting is the way you want, press
3 FUNCTION.
Changing the Beep Setting
To Next Page
Loading...
Need help?
General
Weight and Dimensions
