Playing on the Keyboard
EN-18
Chorus is a function that adds depth and breadth to notes.
1.
Press bp FUNCTION and then use the bo dial
to display “Chorus”.
2.
Press bp ENTER.
This displays the NUM indicator.
3.
Use the bo dial to select the chorus type you
want.
• If you select Setting Number 1 (Tone), appropriate chorus
settings are assigned to each tone.
• The actual effect produced by chorus depends on the tone
you are using.
4.
Press bp ENTER to apply your setting.
This causes the NUM indicator to disappear.
5.
To exit the setting screen, press bq TONE.
The metronome lets you play and practice along with a steady
beat to help keep you on tempo.
■ To start or stop the metronome
1.
Press 3 METRONOME.
This starts the metronome.
2.
Press 3 METRONOME again to stop the
metronome.
■ To change the beats per measure
1.
Hold down 3 METRONOME until the
message “Beat” appears on the display.
2.
Use the bo dial to select a beat setting.
• You can configure the metronome to use a bell sound
for the first beat of each measure of the song you are
playing.
• You can specify a value from 0 to 9 as the number of
beats per measure.
• The bell will not sound if you specify 0 for this setting.
This setting lets you practice with a steady beat,
without worrying how many beats there are in each
measure.
3.
To exit the setting screen, press bp ENTER.
• You can also use the bp FUNCTION button to configure
settings. See function number 43 (Beat) in the “Function
Setting Item List” (page EN-46).
■ To change the metronome sound volume
See function number 44 (Volume) in the “Function Setting
Item List” (page EN-46).
Using Chorus
Setting Number Parameter
1 Tone
2 LightCho
3 Chorus
4 Deep Cho
5 Flanger
Displayed when the chorus type setting is anything other than “Tone”.
Using the Metronome
This indicator moves with each beat.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
