Playing a Built-in Song or a Song on a USB Flash Drive
EN-28
To loop a range of measures in a song, you need to specify
the start measure and end measure of the section you want to
repeat.
■ To loop a specific phrase
1.
If there is no indicator mark next to REPEAT,
press 7 REPEAT to display it.
2.
Perform steps 1, 2, and 3 under “To select a
single built-in song for playback” (page EN-26)
to start song playback.
3.
When playback reaches the beginning of the
section you want to loop, press 8 A-B.
This will make the beginning of the measure that is
playing when you press 8 A-B the beginning of the
loop, and cause the indicator mark next to A-B to start to
flash.
4.
When playback reaches the end of the section
you want to repeat, press 8 A-B again.
This will make the end of the measure that is playing
when you press 8 A-B the end of the loop, and cause
the indicator mark next to A-B to stop flashing.
5.
To return to normal playback, press 8 A-B.
This causes the indicator mark next to A-B to disappear.
You can mute one of the hand parts of a song for playback.
Then you can practice by playing the muted part on the
keyboard. The following types of songs can be used for such
practice: built-in songs,* or CMF format (one type of CASIO
MIDI file) songs* stored on a USB flash drive.
* These songs have part channel information (page EN-29).
■ To play back with one hand’s part muted
1.
Press bs SONG BANK.
2.
Use the bo dial to select a song number.
3.
Use bn PART SELECT to select a part to
practice.
• Each press of bn PART SELECT cycles through part
settings as shown below. On-screen indicators show
the current part selection.
4.
Press bma to start song playback.
5.
To stop song playback, press bma.
Looping Playback of Specific
Song Measures (A-B Repeat)
Start End
These measures are repeated.
Playing Back with One Hand’s
Part Muted
Both hands play back
Right hand muted
Left hand muted
Both hands muted
To Next Page
Loading...
