EN-27
Playing a Built-in Song or a Song on a USB Flash Drive
3.
Press bma.
• This starts song playback. The playback tempo,
current measure, and current beat are shown in the
upper right corner of the display.
• The operations below are supported during song
playback.
• While a song is playing back, you can play along on
the keyboard using the tone (including split and layer
tones) that was selected before song playback was
started.
4.
To stop song playback, press bma.
• The song plays in a continuous loop (repeat on) until
you press bma. To turn off repeat, press
7 REPEAT and confirm that there is no indicator
mark next to REPEAT.
■ To select a tone for keyboard play along with
song playback
1.
While (song bank indicator) is displayed,
press bq TONE.
This displays (tone indicator).
2.
Use the bo dial to select the number of the tone
you want to assign to keyboard play.
• While is displayed, you can perform the split and/or
layer tone selection operation. For more information,
see “Playing on the Keyboard” (page EN-14).
• To change a tone number you selected using the procedure
above, press bs SONG BANK. This causes to
disappear, leaving only displayed.
■ To adjust the balance between song and
keyboard volume
See function number 23 (Song Vol) in the “Function Setting
Item List” (page EN-46).
To perform this operation: Do this:
Stop a song part way
through.
Press bma.
Pause or unpause a song. Press blk.
Change the song playback
speed.
See “Changing the Tempo
Setting” (page EN-19)
Jump to the beginning of the
next measure.
Press bkd.
Fast forward the song Hold down bkd.
Jump to the beginning of the
previous measure.
Press 9s.
Fast reverse the song Hold down 9s.
Indicator disappears when repeat is turned off.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
