Selecting and Playing a Tone
E-13
To adjust the metronome volume
NOTE
• You can perform the following procedure at any time,
regardless of whether or not the metronome is sounding.
1.
Press the TEMPO/SETTING button.
• This will cause the lamp above the button to flash.
2.
Press the METRONOME VOLUME button.
• This will cause the lamp above the button to flash.
3.
Use the /NO and /YES buttons to
change the metronome volume in the range
of 0 to 42.
4.
Press the TEMPO/SETTING button again.
• This will cause the lamp above the button to go out.
AP500_e.book 13 ページ ２００６年１０月１９日 木曜日 午後３時５４分
To Next Page
Loading...
