Recording and Play Back
E-23
To record to one track of a song while
listening to the playback of the other
track
1.
Press the RECORDER button so the PLAY
lamp is lit.
2.
Use the /NO and /YES buttons to
display a song number (1 to 5).
3.
Press the RECORDER button so the REC
lamp is flashing.
• This will cause the L/1 lamp to flash.
4.
Use the PART/TRACK button to select the
track to which you want to record.
• Make sure that the lamp for the record track is
flashing.
Example: To listen to playback of Track 1 as you record
to Track 2
5.
Select the tone and effects you want to use
for your recording.
6.
Press the START/STOP button or play
something on the keyboard to start
simultaneous playback from Track 1 and
recording to Track 2.
• This will start both playback of the recorded track
and recording to the other track.
7.
When you are finished, press the START/
STOP button again to stop recording.
1.
Press the RECORDER button so the PLAY
lamp is lit.
2.
Use the /NO and /YES buttons to
display a song number (1 to 5).
NOTE
• When a song has something recorded in both tracks, you
can turn off one track and play back just the other track,
if you want. Whether a track is on or off is indicated by
the lamps above the PART/TRACK button. Each press of
the PART/TRACK button cycles through the different
possible track on/off settings.
3.
Press the START/STOP button.
• This starts playback of the song and/or track you
selected.
NOTE
• You can change the tempo setting as a track is playing.
• You cannot change the tone setting during playback.
•Press the START/STOP button again to stop playback.
This indicator appears when the track contains recorded
data already.
Lit: Playback standby Flashing: Record standby
Playing Back from Digital
Piano Memory
AP500_e.book 23 ページ ２００６年１０月１９日 木曜日 午後３時５４分
To Next Page
Loading...
