Getting Ready
EN-57
5.
Next, secure the bottom of the back panel
with the six
screws.
6.
Adjust the height adjustment screw
to
provide support so crosspiece
does not
bow downwards when the pedals are
pressed.
• Pressing the pedals without first adjusting height
adjustment screw
can result in abnormal noise
and/or damage to crosspiece
. Be sure to adjust
height adjustment screw
.
7.
Place the piano onto the stand.
• In order to ensure you do not get your fingers
pinched between the piano and the stand, grasp the
piano on its sides (not its ends) at the locations
marked with stars () in the illustration.
• At this time the screws on the bottom of the piano
should hook into the cutouts in the stand brackets
.
At least 10cm
At least 10cm
9
8
Bracket cutout
Back of piano
Stand side panel
To Next Page
Loading...
