365
20-8 Editing File Names and Program Contents
uu
uu
uTo edit a file name
Example To change the name of a file from TRIANGLE to ANGLE
1. While the program list is on the display, use f and c to move the highlight-
ing to the file whose name you want to edit and then press 6 (g) 2 (REN).
2. Make any changes you want.
DDD
3. Press w to register the new name and return to the program list.
• If the modifications you make result in a file name that is identical to the name
of a program already stored in memory, the message “Already Exists”
appears. When this happens, you can perform either of the following two
operations to correct the situation.
•Press e or d to clear the error and return to the file name input screen.
•Press A to clear the new file name and input a new one.
uu
uu
uTo edit program contents
1. Find the file name of the program you want in the program list.
2. Recall the program.
• The procedures you use for editing program contents are identical to those
P. 2 0 used for editing manual calculations. For details, see “Editing Calculations”.
• The following function keys are also useful when editing program contents.
1 (TOP) ....... Moves the cursor to the top
of the program
2 (BTM) ....... Moves the cursor to the
bottom of the program
Example 2 To use the OCTA program to create a program that calculates
the surface area and volume of regular tetrahedrons when the
length of one side is known
P. 353
To Next Page
Loading...
Need help?
General
