English
Playing the Digital Keyboard
EN-9
The metronome lets you play and practice along with a steady
beat to help keep you on tempo.
1.
Press
5
(METRONOME).
This starts the metronome.
2.
Press
5
again to stop the metronome.
You can configure the metronome to use a bell sound for the
first beat of each measure of the song you are playing.
• You can specify 0, or a value from 2 to 6 as the number of
beat per measure.
• When playing a built-in song, the beats per measure setting
(which determines when the bell sounds) is configured
automatically for the currently selected song.
1.
Hold down
5
until the beats per measure
setting screen appears on the display.
• If you do not perform any operation for after the beats
per measure setting screen appears, the display will
return to the screen displayed before you pressed
5
.
2.
Use
bo
(–/+) to enter the number of beats per
measure.
• The bell will not sound if you specify 0 for this setting. In
this case, all beats are indicated by a click sound. This
setting lets you practice with a steady beat, without
worrying how many beats there are in each measure.
Use the following procedure to change the tempo of the
metronome.
1.
Press
6
(TEMPO).
Use w (slower) and q (faster) to change the tempo
setting. Holding down either button changes the setting at
high speed.
• Pressing w and q at the same time will initialize the
tempo setting in accordance with the currently selected
song or rhythm.
• Pressing
6
causes the tempo value to flash on the
display. While the tempo value is flashing, you can use
bo
to change it.
• The tempo value will stop flashing if you do not perform
any operation for a short while.
Using the Metronome
Start/Stop
Changing the Beats per Measure
This pattern changes with each beat.
Bea t
Changing the Metronome Tempo
Tempo value (flashes)
CTK3400SK_A5_x1a_EN_ES.indd 11 2013/10/09 18:58:25
To Next Page
Loading...
