General Guide
EN-4
You can use the [+] (increase) and [–] (decrease) buttons
(
bo
) to change the displayed number or value.
• Holding down either button scrolls the displayed setting.
• Pressing both buttons at the same time will revert to the
initial default setting or the recommended setting.
• Holding down
3
(FUNCTION) while pressing
bo
(–/+) [–]
will decrease the displayed number of value by 10. Holding
down
3
(FUNCTION) while pressing
bo
(–/+) [+] will
increase it by 10.
Use the FUNCTION button (
3
) to access settings that let
you select the reverb type, pedal effect, etc.
1.
Press
3
(FUNCTION).
2.
Next press
3
until the parameter whose
setting you want to change is displayed.
Each press of
3
cycles through the available
parameters.
• When selecting a parameter, you can scroll backwards by
holding down
3
as you press
4
(TOUCH).
3.
When the parameter you want is displayed, use
bo
(–/+) to change its setting.
• The parameter setting will disappear from the upper left
area of the screen if you do not perform any operation
for some time.
• The tone and other parameters revert to their initial
defaults whenever you turn on power (page EN-7).
Using the [–] and [+] Buttons (
bo
)
Mde r nPno
Setting
Using the FUNCTION Button (
3
)
Parameter Display See Page
1 Transpose Trans. EN-13
2 Accompaniment Volume AcompVol EN-19
3 Tuning Tune EN-13
4 Reverb Reverb EN-12
5 Keyboard Channel Keybd Ch EN-25
6 Navigate Channels Navi. Ch EN-25
7 Local Control Local EN-26
8 Accomp Out AcompOut EN-26
9 Pedal Effect Jack EN-12
10 Pitch Bend Range Bend Rng EN-13
Parameter
Setting
Trans .
CTK3400SK_A5_x1a_EN_ES.indd 6 2013/10/09 18:58:24
To Next Page
Loading...
