Keyboard Settings
E-68
Turning on split switches the currently selected part to Part
3, and displays the split tone. At that time, you can use the
[ ] and [ ] CURSOR buttons to switch between parts.
Turning off split returns to Part 1.
The main tone sounds over Channel 1, while the split tone
sounds over Channel 3. You can also use the Mixer to
change the tone and volume settings for these channels.
Note that split is not possible during record standby or
recording in the Song Memory Mode, or while you are
using the SMF Player Mode.
When the accompaniment mode is set to CASIO CHORD
or FINGERED, the accompaniment keyboard range is in
accordance with the split point you specify with the above
procedure.
You can use layer and split together to create a layered split
keyboard. It makes no difference whether you layer tones first
and then split the keyboard, or split the keyboard and then
layer tones. When you use layer and split in combination, the
high range of the keyboard is assigned two tones (main tone
+ layered tone), and the low range two tones (split tone +
layered split tone).
J LAYER SPLIT
1. Press the TONE button and then input the tone
number of the main tone.
Example:
To set “361 BRASS GM” as the main tone.
2. Press the SPLIT button and then input the
number of the split tone.
Example:
To set “345 PIZZICATO GM” as the split tone.
After specifying the split tone, press the SPLIT
button to unsplit the keyboard.
3. Press the LAYER button and then input the
number of the layered tone.
Example:
To set “360 FRENCH HORN GM” as the layered
tone.
4. Press the SPLIT button or the LAYER button so
both of the SPLIT and LAYER indicators are
displayed.
5. Input the number of the layered split tone.
Example:
To specify the “348 STRINGS 1” tone, enter 3, 4,
8.
6. While holding down the SPLIT button, press the
keyboard key where you want the lowest note
(the leftmost key) of the upper range (right side
range) to be.
7. Play something on the keyboard.
Press the LAYER button to unlayer the keyboard,
and the SPLIT button to unsplit it.
Turning on layer+split switches the currently selected part
to Part 4, and displays the layered tone. At that time, you
can use the [ ] and [ ] CURSOR buttons to switch
between parts. Turning off layer returns to Part 3, while
turning off split returns to Part 2. Turning off both layer and
split returns to Part 1.
The main tone sounds over Channel 1, the layer tone over
Channel 2, the split tone over Channel 3, and the layer/split
tone over Channel 4. You can also use the Mixer to change
the tone and volume settings for these channels.
Using Layer and Split Together
To split the keyboard and then layer tones
705A-E-070A
CTK691E01‑01.book68ページ２００３年９月２９日 月曜日 午後４時４７分
To Next Page
Loading...
Need help?
General
