Casio DT-930 - Compliance; 6.10. Chain Connection; 6.10.1. Configurations and Operating Conditions

25
6.9. Compliance
Table 6.7
Standard Remark
Radio interference EN55022:1994, A2:1997 Class B
CISPR Pub.22:1993, A2:1996 Class B
Tested with DT-9020ADP-G.
Electromagnetic
compatibility
generic immunity
EN50082-1: 1997 Tested with DT-9020ADP-G.
Safety EN60950 Applicable to DT-9020ADP-G
and DT-9020ADP-U.
6.10. Chain Connection
6.10.1. Configurations and Operating Conditions
Basic Cradle and Host P/C (with external device connected)
HOST PC
DT-930
Basic
Cradle
RS-232C
IR communication
115.2 Kbps (max.)
115.2 Kbps (max.)
Fig. 6.2
DIP Switch Setting
Table 6.8
No. Use of Switch Destination Switch Setting Remark
1 Baud rate switching 0 To GA IRSPEED0 ON
2 Baud rate switching 1 To GA IRSPEED1 OFF
3 Baud rate switching 2 To GA IRSPEED2 ON
115.2 Kbps
See note.
4 RS To GA RS OFF
5 ER To GA ER OFF
6 Chain termination setting To RS-485 LINE ENDSW ON
7 Use of chain connection To GA RS-485 ON
Note:
This baud rate must be reduced if the line quality is poor.