●
Stopwatch Mode
In this mode, the main hour and minute hands
indicate the current time in your current
location (Home City), while the other hands
show elapsed time as measured by the
stopwatch.
30
①
②
③
④
Split/
Reset
Start/
Stop
A
Stopwatch seconds
B
Stopwatch hours
C
Stopwatch minutes
D
Stopwatch 24-hour hand
The hand points to the A-side for hours 0
through 11, and to the P-side for hours 12
through 23.
●
Timer Mode
The main hour and minute hands indicate the
current time.
The second hand, and the small hour and
minute hands indicate the current countdown
time.
A
Timer seconds
B
Timer minutes
C
Timer hours
D
Timer 24-hour hand
The hand points to the A-side for hours 0
through 11, and to the P-side for hours 12
through 23.
●
Alarm Mode
In this mode, the main hour and minute hands
indicate the current time in your current
location (Home City), while the dial hour and
minute hands show the alarm time setting.
30
Enabling/
Disabling the
Alarm
①
③
②
Illumination
A
Alarm enable/disable
The second hand will point to [ON] while the
alarm is turned on, and to [OFF] while it is
turned off.
l
Turning the Alarm On or Off
B
Alarm time
C
Alarm 24-hour hand
The hand points to the A-side for a.m. times,
and to the P-side for p.m. times.
Using the Crown
The watch’s crown is a screw-in (screw lock)
type. To use the crown, you first need to rotate
it towards you (leftwards) to loosen it.
●
Pulling Out and Pushing In the Crown
To perform a crown operation, pull it out to the
first or second click and then rotate it. Do not
pull the crown with too much force.
First click
Second click
Important!
●
To prevent loss of water resistance
and/or damage due to impact, be
sure to screw the crown in by rotating
it away from you as you push it in.
●
When pushing the crown back in,
take care not to apply too much
force.
Operation Guide 5560
3
To Next Page
Loading...
Need help?
General