E-59
Adjusting the Home Positions
Strong magnetism or impact can cause the hands and/or date of the watch to be
off, even if the watch is able to perform the signal receive operation. If this happens,
perform the applicable home position adjustment procedures in this section.
Note
Any time after you enter the home position adjustment mode in step 1 of the following
procedure, you can return to the Timekeeping Mode by pressing A. The watch also
will return to the Timekeeping Mode automatically if you do not perform any operation
for about two or three minutes in home position adjustment mode. In either case, any
adjustments you made before the watch returned to the Timekeeping Mode will be
applied.
To adjust the home positions
Hold down 1. C for about two seconds until the watch beeps twice and enters the
Timekeeping Mode.
Hold down 2. D for about three seconds until the watch beeps.
To Next Page
Loading...
Need help?
General