112
Dynamic Photo
3. If you are inserting a subject into a movie an
image will appear on the monitor screen
showing the approximate location of the
subject in the movie. Use [4] and [6] to shift
the location to the position you want. After you
are finished, press [SET].
• If you insert a subject into a movie, the resulting movie will be a maximum of 20
seconds long. Everything before and after the insertion is cut off. If the movie
you are inserting into (original movie) is shorter than 20 seconds, the resulting
movie will be the same length as the original movie.
• If you are inserting a subject into a snapshot, skip directly to step 4.
4. Use the zoom controller to adjust the size of the subject and use [8],
[2], [4], and [6] to adjust its position.
5. When everything is the way you want, press [SET].
This inserts the subject into another image and creates a Dynamic Photo.
• Inserting an animated subject into a snapshot will save a Dynamic Photo that
consists of 20 still images of 2M size or smaller.
• Inserting a stationary subject into a snapshot will save a single still image of 6M
size or smaller.
• Inserting a subject into a movie will save the Dynamic Photo as a movie file.
NOTE
• The camera comes with a number of extracted sample subjects in its built-in
memory, which you can use to create Dynamic Photos, if you like.
• Performing a delete or format operation will not delete the extracted sample
subjects in built-in camera memory.
Insert location
B
To Next Page
Loading...
Need help?
General
