128
Appendix
If the [CHARGE] lamp flashes red...
• Charging cannot be performed because ambient temperature or the temperature of
the charger is too hot or too cold. Leave the camera in a location whose
temperature is within the range where charging can be performed. When the
camera returns to a temperature where charging can be performed, the [CHARGE]
lamp will light red.
• Check if the charger and battery contacts are dirty. If contacts are dirty, wipe them
clean with a dry cloth.
1. Open the battery cover and
remove the current battery.
With the monitor screen side of the
camera facing upwards, slide the
stopper in the direction indicated by
the arrow in the illustration. After the
battery pops out, pull it the rest of the
way out of the camera.
2. Load a new battery.
Power Supply
Charging
If problems continue to occur after you perform the above steps, it could mean that
the battery is faulty. Contact your nearest CASIO authorized service center.
To replace the battery
Stopper
To Next Page
Loading...
Need help?
General
Weight and Dimensions
