85
Using the Camera with a Computer
Installing the CASIO Connection powered by Eye-Fi that comes with
the camera on your computer makes it possible to upload image data
(photographs and movies) to an online service.
. To install CASIO Connection powered by Eye-Fi on your computer
1. Start up your computer and connect to the Internet.
• CASIO Connection powered by Eye-Fi cannot be installed on a computer that
is not connected to the Internet.
2. Turn off the camera and then remove its memory card (page 114).
3. Connect the USB cable
that comes with the
camera to the camera
and to the USB port of
your computer.
• Note that even while the
connector is fully
inserted, you still will be
able to see the metal part
of the connector as
shown in the illustration.
4. Windows 7, Windows Vista users: Click “Start” and then “Computer”.
Windows XP users: Click “Start” and then “My Computer”.
5. Open “Removable Disk” and then double-click “setup.exe”.
This will start up the CASIO Connection powered by Eye-Fi installer.
6. Follow the instructions that appear on your computer screen to install
the software.
7. Follow the instructions that appear on the display to register as a
CASIO Connection powered by Eye-Fi user and to log in.
Uploading Image Data to an Online Service
USB port
USB cable (included)
[USB] port
Large connector
Small connector
Making sure that the 8 mark on the USB cable
connector is towards the side opposite that of the
monitor screen, connect the cable to the camera.
To Next Page
Loading...
Need help?
General
