EasyManua.ls Logo

Casio fx-570EX - Clearing the Contents of All Memories; Function Calculations; Pi π and Base e; sin, cos, tan, sin⁻¹, cos⁻¹, tan⁻¹

Casio fx-570EX
46 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Clearing the Contents of All Memories
Ans memory, independent memory, and variable contents are retained even
if you press , change the calculation mode, or turn off the calculator.
Perform the procedure below when you want to clear the contents of all
memories.
(RESET)(Memory)(Yes)
Function Calculations
Note: To interrupt an ongoing calculation before its result appears, press
.
Pi π: π is displayed as 3.141592654, but π = 3.14159265358980 is used for
internal calculations.
Natural Logarithm Base e: e is displayed as 2.718281828, but e =
2.71828182845904 is used for internal calculations.
sin, cos, tan, sin
-1
, cos
-1
, tan
-1
: Specify the angle unit before performing
calculations.
sin 30° =
1
2
(Angle Unit: Degree)
30
1
2
sinh, cosh, tanh, sinh
-1
, cosh
-1
, tanh
-1
: Input a function from the menu that
appears when you press (Hyperbolic Func)*
1
. The angle unit setting
does not affect calculations.
*1 Depending on the calculation mode, you should press .
,
r
,
g
: These functions specify the angle unit. ° specifies degree,
r
radian,
and
g
gradian. Input a function from the menu that appears when you
perform the following key operation: (Angle Unit)*
2
.
π/2 radians = 90° (Angle Unit: Degree)
(π)2(Angle Unit)(
r
)
90
*2 Depending on the calculation mode, you should press .
, : Exponential functions.
e
5
× 2 = 296.8263182
(MathI/MathO)
() 52
296.8263182
(LineI/LineO)
() 52
296.8263182
log: Logarithmic function. Use (log) to input log
a
b as log (a, b).
Base 10 is the default setting if you do not input anything for a.
log
10
1000 = log 1000 = 3
(log) 1000
3
log
2
16 = 4
(log) 2(,) 16
4
The key also can be used for input, but only while MathI/MathO or
MathI/DecimalO is selected for Input/Output on the setup menu. In this
case, you must input a value for the base.
log
2
16 = 4
216
4
ln: Natural logarithm to base e.
ln 90 (= log
e
90) = 4.49980967
90
4.49980967
x
2
, x
3
, , , , , x
-1
: Powers, power roots, and reciprocals.
(1 + 1)
2+2
= 16
1122
16
(5
2
)
3
= 15625
5(x
3
)
15625
32
5
= 2
(MathI/MathO)
() 532
2
14

Related product manuals