— 8 —
5. ERROR MESSAGE
Meaning
1 Calculation formula contains an error.
2 Formula in a program contains an
error.
1 Calculation result exceeds calcula-
tion range.
2 Calculation is outside the input range
of a function.
3 Illogical operation (division by zero,
etc.)
4 Poor precision in differential calcula-
tion results.
1 No corresponding Lbl n for Goto n.
2 No program stored in program area
Prog “file name”.
3 No corresponding “Next” for “For”, no
corresponding “LpWhile” for “Do”, or
no corresponding “whileEnd” for
“While”.
• Nesting of subroutines exceeds 10
levels.
• Execution of calculations that exceed
the capacity of the stack for numeric
values or stack for commands.
Message
Syn ERROR
Ma ERROR
Go ERROR
Ne ERROR
Stk ERROR
Countermeasure
1Use or to display the point
where the error was generated and
correct it.
2Use or to display the point
where the error was generated and
then correct the program.
123
Check the input numeric value and
correct it.
When using memories, check that the
numeric values stored in memories
are correct.
4Try using a smaller value for ∆ x
(x increment/decrement).
1Correctly input a Lbl n to correspond to
the Goto n, or delete the Goto n if not
required.
2Store a program in program area Prog
“file name”, or delete the Prog “file
name” if not required.
3Correctly match “Next” with “For”,
“LpWhile” with “Do”, or “whileEnd”
with “While”.
• Ensure that Prog “file name” is not
used to return from subroutines to
main routine. If used, delete any un-
necessary Prog “file name”.
• Trace the subroutine jump destina-
tions and ensure that no jumps are
made back to the original program
area. Ensure that returns are made
correctly.
• Simplify the formulas to keep stacks
within 10 levels for the numeric values
and 26 levels for the commands.
• Divide the formula into two or more
parts.
To Next Page
Loading...
Need help?
General
