E-41
To set the timer start time
1
In the Timer Mode, hold down A for about two seconds.
[SET Hold] will appear on the display. After that, [SET
Hold] will disappear and the hours digits will flash.
Note
• If a timer countdown operation is in progress, press
D to stop it and then press B to reset the timer to
its start time before performing the above step.
• If a timer countdown operation is paused, press B
to reset the timer to its start time before performing
the above step.
2
Each press of C causes the flashing to move between the hours and the
minutes digits.
The flashing digits are the ones that are selected.
To Next Page
Loading...
