To Next Page

To Previous Page

All Text Operations

The procedures in this section control the following parameters for all of the text on the display.

• Mirror printing (mirror, normal)

• Proportional character spacing (on, off)

• Smoothing (on, off)

• Block space (none, narrow, wide)

• Feed (long, short, manual)

• Tape length (auto, fixed)

• Block alignment (left, center, right, uniform spacing)

Use the BLOCK FORM menu to perform block operations.

To display the ALL FORM menu

1. While there is text on the display, press FORM.

2. Use u and i to move the highlighting to ”ALL FORM” and then press SET.

• Use u and i to move the highlighting between menu items.

• The ALL FORM menu has three pages. Press SET while the first page is displayed to change to the second page. Press SET while the second page is displayed

to change to the third page. Pressing SET while the third page is displayed registers any settings with the menu and returns to the text input screen.

• Use t and y to change between settings of the currently selected (highlighted) item.

• The following explanations describe each of the ALL FORM menu items in detail.

MIRROR/NORMAL

MIRROR

NORMAL

PROPORTIONAL

OFF

SMOOTHING

OFF

BLOCK SPACE

NONE WIDE

NARROW

FEED

You can also one of two different feed settings that provides either long or short side spaces (”Fundamentals of Label Layout” page E-16). You can also specify

manual feed.

LONG

This setting causes the tape to feed 16mm at the beginning and end of each printing.

SHORT

This setting causes the tape to feed 3mm at the beginning and end of each printing.