EN-9
Overview and Setup
■ To specify the pedal type
You can use FUNCTION parameter 42 (“Pedal Type”) to
select one of the settings below.
• Note that the expression pedal polarity type depends on the
manufacturer. When connecting an expression pedal,
select “Exp.Type1” or “Exp.Type2” in accordance with its
polarity type.
• For information about FUNCTION parameters, see
“Configuring Function Settings (FUNCTION Mode)” (page
EN-53).
■ To specify the pedal function
You can use FUNCTION parameter 43 (“Pedal Target”) to
select one of the settings below. The settings from
“Expression” to “Layer Balance” are expression pedal
settings, while the settings from “Sustain” to “Fill-in” are switch
type (CASIO sustain) pedal settings.
• For information about FUNCTION parameters, see
“Configuring Function Settings (FUNCTION Mode)” (page
EN-53).
■ Expression Pedal Calibration
When connecting an expression pedal to the
dl EXPRESSION/ASSIGNABLE jack for the first time,
perform the calibration operation below.
1.
Connect an expression pedal to the
dl EXPRESSION/ASSIGNABLE jack.
2.
Hold down the bp^ button until “[FUNCTION]”
appears on the display.
This enters the FUNCTION Mode.
3.
Use the bk U and bl I buttons to display
“PEDAL/WHEEL” and then touch bm ENTER.
4.
Use the bk U and bl I buttons to display
“EXP/ASGN PEDAL” and then touch
bm ENTER.
5.
Use the bk U and bl I buttons to display
“Exp Calibration” and then touch bm ENTER.
This displays “Sure?”. If you want to cancel the operation
at this point, touch bk – here.
Select this
setting
(displayed
setting name):
To connect this type of pedal:
SW Switch type pedal (CASIO sustain
pedal)
Exp.Type1 Polarity Type 1 (see the illustration
below) expression pedal
Exp.Type2 Polarity Type 2 (see the illustration
below) expression pedal
Select this
setting
(displayed
setting name):
To assign this function to the pedal:
Expression Expression (MIDI Control Change 11)
control
Master Volume Overall Digital Piano volume level
control
Tempo Tempo control
Layer Balance Upper1 part and Upper2 part volume
level balance control
Sustain
Same as “Sustain” to “Fill-in” under “To
change the function of the pedal
connected to the DAMPER PEDAL
jack” (page EN-7).
Sostenuto
Soft
Arpeggio Hold
Play/Stop
Fill-in
To Next Page
Loading...
Need help?
General
Weight and Dimensions
