EN-41
Digital Piano Operations
■ To register a setup
• Specifying a bank and area that already has data stored
to it in the procedure below causes the recorded data
to be deleted. For information about banks and areas,
see “Setup Storage Locations” (page EN-40).
1.
Use the 3 mode selector button to cycle
through settings until the “RHYTHM” or
“ACCOMP” indicator is lit.
2.
Configure the Digital Piano with the setup you
want to register.
3.
Use the bp^ button to cycle through settings
until the “^REG.” indicator to the right of the
button is lit.
4.
Select bank you want to use as the registration
destination.
• Touch bq BANK to cycle to the next bank number.
• Use the bk – and bl + buttons to select a bank
number.
5.
Select the area where you want to store the
setup.
While holding down cl STORE, touch an area button
from br Area 1 to ck Area 4.
This causes “Sure?” to appear on the display.
• To exit setup registration at this time, touch bk –.
6.
To register the setup, touch bl +.
This completes the registration operation and displays
“Complete”.
■ To recall a registered setup
1.
Use the 3 mode selector button to cycle
through settings until the “RHYTHM” or
“ACCOMP” indicator is lit.
2.
Use the bp^ button to cycle through settings
until the “^REG.” indicator to the right of the
button is lit.
3.
Enable or disable the freeze function as
required.
• The “FZ” indicator on the display indicates that the
freeze function is enabled. There is no indicator when
the function is disabled. To toggle the freeze function
setting between enabled (“FZ” displayed) and disabled
(“FZ” not displayed), hold down the bq BANK button.
• For details about the freeze function, see “Freeze
Function” (page EN-42).
4.
Use bq BANK, or bk – and bl + to select the
bank of the setup you want to recall.
Registering and Recalling a Setup
[
REG I STRAT I ON
]
Bank : 02
[
STORE
]
2-1
–
NO YES
+
Su r e?
Bank number - Area number
[
REG I STRAT I ON
]
FZ
Bank : 02
To Next Page
Loading...
Need help?
General
Weight and Dimensions
