Note1: For information about the relationship between setting values and send/receive values, see “13.5 Pan Setting Value
Table” in “IV Setting Values and Send/Receive Values”.
Transmit Sent when part pan is used.
Sent when the knob is operated by setting. (PX-S6000)
Receive Receipt changes the pan of the corresponding part.
7.7 Expression Controller (0BH)
Message Format: BnH 0BH vvH
n: MIDI Channel Number
vv: Value
Transmit Sent when the pedal is operated by setting.
Receive Receipt changes the Expression value.
7.8 Damper pedal (sustain) (40H)
Message Format: BnH 40H vvH
n: MIDI Channel Number
vv: Value
Transmit Sent when a pedal that has a sustain function is operated.
Receive Receipt performs an operation equivalent to a sustain pedal operation.
Timbre Type Specific Operation This operation differs in accordance with the Timbre Type (see
“About the Timbre Type” in “8 Program Change”) setting.
• Timbre Type: Melody,Hex Layer
Sustain off/on control is performed in accordance with the value of the received message. For
information about the relationship between setting values and send/receive values, see the 13.1
Off/On Setting Value Table
in
IV
Setting Values and Send/Receive Values
.
• Timbre Type: Piano
Continuous control of the following is performed in accordance with the value of the received
message.
– Piano note decay rate
For information about the relationship between setting values and send/receive values, see 13.2
Sustain Pedal Setting Value Table in IV Setting Values and Send/Receive Values.
• Timbre Type: LM (Linear Morphing) Piano
Continuous control of the following is performed in accordance with the value of the received
message.
– Piano note decay rate
9
To Next Page
Loading...
