— 41 —
[ 9 ] Locale information write
[Function]
The Locale information is written into FLASH MEMORY.
[Operation]
The test does not end unless inputting OK or NG key when the one time check is selected.
Operation : x1 x2 0 0 1 6 SUBTOTAL
x1: xcountry code, x2: SUB CODE
x1x2: 10 Europe, 20 US, 30 UK, 40 Germany,
50 Canada, 60 Direct, 61 Direct (Hebrew)
[PRINT]
The following receipt is not issued when commands other than the above are inputted.
LOCALE x1x220016
LOCALE OK
END x1x220016
The following is printed when an error occurs during writing LOCALE.
| LOCALE NG |
The LOCALE can be written 5 times. When no more LOCALE can be written
(writing more than 5 times), the following is printed.
| LOCALE OVER |
[ 10 ] Display test
[Function]
Dots, 7 segments and tact switch display tests are performed (all dots displayed and all LEDs lit)
[Operation]
Press any key to end the test when performing one time check.
Operation : n 0 2 1 SUBTOTAL
n: 0 = One time check (can be omitted)
not 0 = Continuous check (To stop the test, press “C” key)
* Any key must be pressed to end the test when performing one time check.
[LCD]
All dots are displayed.
The display is maintained after the test until any key is pressed.
[7 segment display]
All the 7 segments, transaction and LEDs turn on.
They all turn off after the test
To Next Page
Loading...
