— 52 —
[ 23 ] Time setting
[ 24 ] Time display
[Function]
This sets the time and date.
When setting the time, the time and date will be displayed without inputting the fixed value.
[Operation]
* Date and time setting
Operation : x1 x2 x3 x4 x5 x6 0 a 7 0 SUBTOTAL
a: 0: time setting x1/x2: time, x3/x4: minutes, x5/x6: second
1: time setting x1/x2: year, x3/x4: month, x5/x6: day
The test will be done one time.
* Date and time display
Operation : 7 0 SUBTOTAL
To stop the operation, press “Esc” key. Date and time will be continuously displayed until “C”
is pressed.
[Print]
Each data will be printed only when setting the date and
time.
DATE/TIME 70
DATE/TIME YY/MM/DD HH:MM-SS
END 70
[ 25 ] Drawer open test
[Function]
This test will check the drawer open function.
The test ends by the judgment of the operator either by OK or NG only when the one time check is
selected.
[Operation]
Operation : x n 0 9 1 SUBTOTAL
x: 0 = All drawers open (can be omitted)
1 = Drawer 1 open
(The input numbers, for example, 2 and 3, correspond to the drawer numbers. Up to drawer
4 can be tested.)
n: 0 = One time check (can be omitted)
not 0 = Continuous check (To stop the test, press “C” key)
* When the continuous check is selected, the drawer opens every 2 seconds.
* The following “OK” or “NG” key can be used in case of one time check.
”OK” = 1
”NG” = 9
[Print]
DRW xn091
DRW ALL OK
END xn091
To Next Page
Loading...
Need help?
General
