— 5 —
3. Machine Initialization
3-1.How to initialize the terminal
Preparation:
1. All peripheral devices and terminals of this cluster should be
turned off.
2. Connect all of the peripheral devices (such as printer,
display etc.) to terminal.
3. Connect all terminals by in-line.
Operation:
4. Turn on all peripheral devices of a terminal.
5. Turn on this terminal with pressing the Journal feed key and
release the key after the “Copyright” window is shown.
6. After releasing the key, enter “20000” (U.S.)/ “10000” (other
area: English), “40000” (other area: German), “50000” (other
area: French), “60000” (other area: Spanish) and press the
<ST> key.
7. Enter the current date (YY/MM/DD order) and time and press
the <YES> key.
8. In ID character field, the auto-defined ID No. is shown.
We recommend that you should not change the value.
9. In this field, you can select “1. Master/2. Backup Master/3.
Satellite/4. Selfmaster.”
Please select one of these options and press the <YES> key.
Date 00-00-00
Time 12:34 00
ID Character MC #01
Check System Master
Check cluster ID 0
R/J/Order printer1 UP-350
R/J/Order printer2 UP-350
Slip Printer SP-1300
OK? YES
Date 01-10-10
Time 12:34 00
ID Character MC #01
Check System Master
Check cluster ID 0
R/J/Order Printer1 UP-350
R/J/Order Printer2 UP-350
Slip Printer SP-1300
OK? YES
Date 01-10-10
Time 12:34 00
ID Character MC #01
Check System Master
Check cluster ID 0
R/J/Order Printer1 UP-350
R/J/Order Printer2 UP-350
Slip Printer SP-1300
OK? YES
Date 01-10-10
Time 12:34 00
ID Character MC #01
Check System Master
Check cluster ID 0
R/J/Order Printer1 UP-350
R/J/Order Printer2 UP-350
Slip Printer SP-1300
OK? YES
To Next Page
Loading...
Need help?
General
