— 19 —
11. LED check
1 Press “TEMPO쑼” button.
2 LEDs illuminate in the following order.
FULL RANGE CHORD
FINGERED
CASIO CHORD
DATA ACCESS
DRAWBAR ORGAN
DSP
12.LCD check
1 Press “TEMPO쑿” button.
2 Turn on all segments of the LCD.
13. Card check (If no smart media card, this check can be skipped)
1 Press “-” button.
“Err NO CARD” appears and an NG sound sounds when no card is inserted.
14. FDD check (If no Floppy disc, this check can be skipped)
1 Press “+” button.
“Err NO disc” appears and an NG sound sounds when no card is inserted.
15. Bender check
1 Press “MODE” button.
2 Turn the “PITCH BEND WHEEL” to MAX.
3 Turn the “PITCH BEND WHEEL” to MIN.
16. Modulation check
1 Press “ONE TOUCH PRESET” button.
2 Turn the “MODULATION WHEEL” to MAX.
3 Turn the “MODULATION WHEEL” to MIN.
17. TUNE check (If no TUNING METER, this check can be skipped)
1 Connect the TUNING METER to the phone jack.
2 Press “8” button.
3 The TUNING METER must indicate "C".
4 Disconnect the TUNING METER from the phone jack.
18. APO check
1 Press “EXIT” button.
* Go out from TEST mode (Power off).
* The LCD turns off.
DIAGNOSTIC PROGRAM IS FINISHED.
Message on LCD
1 SMC CHK
앗
1 CARD OK
1 BEND CHK
2 127
1 BEND CHK
2 000
1 BEND OK
1 Exiting
1 FDD CHK
앗
2 Ab8
1 DISK OK
1 MOD CHK
2 000
1 MOD CHK
2 127
1 MODW OK
1 LED CHK
앗
앗
앗
앗
앗
앗
앗
1 LED END
To Next Page
Loading...
