• The following shows input switching instruction and input switching query parameters and
their corresponding input sources.
Parameter
Input
Source
COMPUTER
Terminal Setting
Remarks
11 Computer Auto On the XJ-H1650, XJ-H1750, XJ-H2650,
XJ-ST145, and XJ-ST155 the input source is
Computer 1.
12 Computer RGB ''
13 Computer Component ''
14 Computer2 Auto XJ-H1650, XJ-H1750, XJ-H2650, XJ-ST145,
XJ-ST155 only
15 Computer2 RGB ''
16 Computer2 Component ''
21 Video
22 S-video
31 HDMI
41 USB
• Image only mute is not supported by the AV mute instruction and AV mute state query.
• The cover open error and filter error are not supported by the error state query.
• A projector name query returns the projector name specified on the System Admin Page. For
details about the System Admin page, see "System Admin Page Operations and Settings" in
the "Wireless Function Guide" on the CD-ROM that comes with the projector.
• A manufacturer name query returns CASIO
CASIOCASIO
CASIO.
• A device name query returns XJ
XJXJ
XJ-
--
-NP
NPNP
NP.
• The password used for the connection authentication process is the same as the System
Admin page password. The Projector can be configured to enable or disable authentication. To
do so, use [Wired LAN Settings]-[PJLink authentication] on the Projector's Setup Menu.
E
EE
En
nn
nable
ableable
able : PJLink connection authentication enabled. (Default)
Disabl
DisablDisabl
Disable
ee
e : PJLink connection authentication disabled.
• Up to firmware version *.0.3.1, when the digest generated by the password is appended to the
command and sent to the projector during the authentication process, all of the letters
included in the digest must be upper-case.
Example: a6bb86c8a36e251485e539e7abb71b50%1POWR
↓
A6BB86C8A36E251485E539E7ABB71B50%1POWR
From firmware version *.0.3.2 onwards, the digest is accepted even if it contains lower-case
letters.
For information about the functions of other commands, see the PJLink specifications issued by
To Next Page
Loading...
Need help?
General
