Design and Function
caso Vakuumierer VC10 49
15 Design and Function
This chapter provides you with important safety notices on the
design and function of the device.
15.1 Complete overview
A Seal only For sealing the bag without
vacuum.
B Indicator lamp (for seal) For indicate the
seal process.
C Cancel (Stop) For switch off the vacuuming
and sealing action whenever the operator
wants to stop the operation.
D Indicator lamp (for vacuum) For indicate
the vacuum process.
E Vacuum/Seal For draw air out of the bag
and automatically change operation to seal
the bag after vacuum is completed.
F Cover-lock To lock the cover. On the left
side and right side of the cover there is a
key-press.
G Cover-unlock Press to unlock the cover.
If you open the cover, you see the
Sealing strip: Contains a heating wire covered with Teflon
which allows the bag to seal but not to stick to the strip.
Warning
Please observe the following safety notices in order not to burn
or scald yourself or others.
► To avoid getting burned, never touch the sealing bar while
the unit is operating.
15.2 Rating plate
The rating plate with the connection and performance data can
be founded on the back of the device.
To Next Page
Loading...
