Cassida Corporation • 11035 Technology Place, Suite 500 San Diego, CA 92127 • www.CassidaUSA.com
©2019 Cassida Corporation. All rights reserved. Specifications subject to change without notice. Cassida is a registered trademark of the Cassida Corporation.
REV0919
COUNT SENSOR CLEANING (E1 – E8 ERROR TROUBLESHOOTING).
4. Refer pictures below to locate counting sensors (one dark, one clear)
positioned at the top of the coin discharge chutes which are placed
under the distribution wheel.
B. A pair of count sensorsA. Coin discharge chutes
3. Remove the housing by slowly lifting
straight up. Be aware two cables will
remain attached to the housing.
CAUTION: Do not pull or twist
the cables.
C300
Cleaning Procedure
4
5
3
2
1
To Next Page
Loading...
