FH100 Precision Variable-Speed Peristaltic Pump System Operating Manual 2-1Cole-Parmer
Section 2 Installation and Setup
Unpack the pump and retain all packing material until proper product
operation has been verified. Select the tubing according to the flow
desired, while considering chemical compatibility and tubing life.
Flow rate is determined by the size of the tubing in the Pump Head.
When tubing links are used, best performance will be achieved when input
and output tubing connected to the link are the same ID as the link.
77722-00 Pump Systems accept tubing ID sizes of 0.8 mm to 8.0 mm
(1/32 in to 5/16 in ) by 1.6 mm (1/16 in) wall.
77722-02 Pump Systems accept tubing ID sizes of 4.8 mm to 9.5 mm
(3/16 in to 3/8 in) by 2.4 mm (3/32 in) wall.
For best results, select a tubing size with a mid-range at the desired flow
rate to be pumped.
Tubing Size Selection
To Next Page
Loading...