1. Read instructions before operating the unit.
2. Observe safety precautions at all times, especially when pumping
dangerous liquids. Always have the clear plastic cover properly
mounted on the Pump Head and, in general, protect the pump area
from accidental spillage of liquid.
3. If the pump runs unusually noisily or if bunching of the tubing in the
pump can be observed, make sure the tubing is clamped down tightly
and/or replace it with a new piece of tubing.
4. The FH100 Pump System must be well-grounded at all times.
5. The FH100 Pump System is equipped with a current-limiting circuit
that will slow the motor down if any of the following conditions exist:
a. Tubing that is too hard is loaded in the pump.
b. Incorrect tubing size or wall thickness is loaded in the pump.
c. Tubing is improperly loaded into the Pump Head.
6. The unit is fused and grounded to protect the operator in the event of
short circuits that could be caused by liquid entering the case.
CAUTION: Replace the fuse only with one of the same type
and rating. The fuse rating and type are stated on the
rear panel.
7. The Pump System should not be used in outdoor or hazardous
locations.
Safety
Cole-Parmeriv FH100 Precision Variable-Speed Peristaltic Pump System Operating Manual
Preface
To Next Page
Loading...