CaterSense -01 User Manual

CaterSense the Intelligent answer
CS-INST1-0.01
Model: CaterSense 01 Page 3 07-11
1) To open the enclosure, first remove the snap-in clips at the bottom of the two side
panels: using a flat bladed screwdriver push the clip from below away from each side
panel.
2) Press the release pad on each side at the bottom of the enclosure and lift off each
side panel in turn by first pulling the bottom towards you. This will reveal the four
facia plate fixing screws.
3) Unscrew these four screws and lift the facia plate from the back box (3), ensuring that
the ribbon cable between the two PCBs has been unplugged at the main PCB end.
Place the screws, snap-in clips, side panels and facia plate in a safe place until the back box
has been fixed, wired and is ready for reassembly and set-up.
1.
3.
2.
x 2

CaterSense -01 Specifications

General

Brand	CaterSense
Model	-01
Category	Controller
Language	English