Catler ES 4050 - Care & Cleaning

18
CARE & CLEANING
CARE & CLEANING
WARNING
ENSURE THE APPLIANCE IS SWITCHED OFF, COOLED DOWN AND
UNPLUGGED FROM THE POWER OUTLET BEFORE CLEANING. DO NOT USE
PETROL, SOLVENTS, ALCALIC AGENTS OR ANY OTHER SIMILAR LIQUIDS
FOR CLEANING.
FOLLOW THE INSTRUCTIONS STATED IN THIS CHAPTER.
INSLATALLING/REPLACING THE FILTER IN THE WATER TANK
Soak the water fi lter for
5 minutes.
Rinse fi lter and mesh. Assemble. Set date 2 months ahead. Install fi lter in water tank. Insert and lock the
water tank.
REPLACEMENT DUE
To purchase water  lters contact your dealer.
NOTE
MACHINE CLEANING
After regular use, residual grinds and oil
build up in the machine can a ect co ee
extraction. We recommend performing
acleaning cycle every 2-3 months using the
cleaning tablet provided.
To perform acleaning cycle:
1. Insert the silicon disk into the porta lter.
2. Place the cleaning tablet on the silicon
disk (position in the centre).
3. Insert the porta lter into the group head
and rotate to right to lock in position.
4. Ensure Power On/O button is on.
5. Turn the dial to the
position for
20seconds.
6. Turn the dial back to the ‘I’ position.
7. Repeat steps 5-6 three times or until the
cleaning tablet is dissolved.
The water  lter provided helps to prevent
scale build up which over time can a ect the
performance of your machine, potentially
causing blockages and heating problems.
Replacing the water  lter every two months will
reduce the mineral build up in the machine.
If you live in ahard water area, we
recommend you change the water  lter
more frequently.
Replacing the water  lter
• Remove the  lter from the plastic bag,
and soak in acup of water for 5 minutes.
• Rinse the  lter under cold running water
for 5 seconds.
• Wash the stainless steel mesh in the
plastic  lter compartment with water and
assemble.
• Set the date dial 2 months ahead.
• To install, push down to lock into place.
The water  lter can be removed from
the water tank during operation if not
required.
PORTAFILTER CLEANING
Periodically run water through the machine
with the porta lter in place, but without
any ground co ee, to rinse out any residual
co ee particles.