Catler ES 4050 - Page 19

19
CARE & CLEANING
DECALCIFYING
After regular use, hard water can cause
mineral build up in and on many of the
internal components, reducing water  ow,
power of the machine, and a ecting the
quality of co ee. We advise decalcifying
the machine on aregular basis (every 2-3
months) using amixture of white vinegar
and water.
Solution for decalcifying
Diluted Solution (for softer water).
• 1 part white vinegar
• 2 parts cold tap water
Concentrated Solution (for harder water)
• 1 part white vinegar
• 1 part cold tap water
If an alternative decalcifying agent is used,
please follow the manufacturer’sinstructions
speci ed.
NOTE
DECALCIFYING THE MACHINE
• Ensure the Control Dial is in the ‘I’
position, the Power On/O button is o
and the machine is switched o at the
power outlet and unplugged.
• Remove the  lter holder and pour the
mixture of white vinegar and water into
the water tank.
• Plug the machine into the power outlet
and switch on.
• Ensure Power On/O button is on and
the Control Dial is on the ‘I’ position.
• Place alarge container under both the
Group Head and the Steam Wand.
• Set the Control Dial to the
position
and let half the mixture of white vinegar
and water run through the Group Head.
• Set the Control Dial to the
position
and allow the remaining liquid to run
through the Steam Wand. When the
liquid stops  owing, set the Control Dial
back to the ‘I’ position.
• After decalcifying, remove the water tank
and rinse thoroughly then re- ll with
fresh cold water.
• To rinse the machine, run half the water
through the Group Head and half
through the Steam Wand.
• The machine is ready for use.