Catler ES 4050 - Page 20

20
CARE & CLEANING
CLEANING THE STEAM WAND
Run steam to clean milk from
wand after texturing.
Wipe steam wand after each use. Clean hole with pin. Remove tip. Soak tip overnight then re-attach.
CLEANING FILTER BASKETS
Should the  ne holes in the  lters become
blocked follow the steps below:
1. Place the  lter into the porta lter. Run
water through the machine with the
 lter and porta lter, without any ground
co ee, in place.
2. Apin can be used to clear the  lter
basket holes.
3. For athorough clean of the  lters,
dissolve acleaning tablet in hot water
and soak  lters overnight.
CLEANING THE OUTER HOUSING / CUP
WARMING PLATE
The outer housing and cup warming plate
can be cleaned with asoft, damp cloth. Then
polish with asoft, dry cloth.
Do not use abrasive cleansers, pads or cloths
which can scratch the surface.
CLEANING THE DRIP TRAY
The drip tray should be removed, emptied
and cleaned at regular intervals.
Wash the drip tray with warm soapy water,
using anon-abrasive washing liquid, rinse
and dry thoroughly. The drip tray base and
cover are dishwasher safe.
CLEANING THE STORAGE TRAY
The storage tray can be removed after the
drip tray is removed then cleaned with asoft,
damp cloth (do not use abrasive cleansers,
pads or cloths which can scratch the surface).
STORING YOUR MACHINE
Before storing, press the POWER button to
o , turn the Control Dial to ‘I’ and unplug.
Insert all accessories into position or into the
storage tray.
Store upright. Do not place anything on top.
WARNING
DO NOT IMMERSE POWER
CORD, POWER PLUG OR
APPLIANCE IN WATER OR
ANY OTHER LIQUID. THE
WATER TANK SHOULD
NEVER BE REMOVED OR
COMPLETELY EMPTIED
DURING DECALCIFYING.