Catler ES 8010 - Page 16

STEP 7 - BREWING THE COFFEE
• The red ‘Heating’ light cycles o when
the machine has reached the correct
temperature for brewing.
• Ensure the Drip Tray and Grid are in place.
• Place one or two pre-warmed cups
beneath the Filter Holder outlet.
• Set the Selector Control to the ‘Espresso’
position.
• After a few seconds, aromatic co ee will
begin to brew into the cups. A pumping
noise will be heard in this operation.
• When su cient co ee has  owed into
the cups, set the Selector Control to the
‘Standby’ position. This will stop the  ow of
co ee.
• If the steam function is not required,
leave the Selector Control to the ‘Standby’
position, unplug the power cord and allow
the machine to cool.
PRE-BREW FUNCTION
• When the Selector Control is set to the
‘Espresso’ position, the 15 bar pump
pumps water momentarily, followed by
a pause, then continues to pump the water
through to the ground co ee in the Filter
Holder. The ground co ee is moistened
by a small amount of water before full
extraction and expands resulting in greater
pressure build-up to extract all the oils and
full  avour from the ground co ee. The
ground co ee expands and when greater
pressure is built up, the brewed co ee is
extracted with its full  avour.
NOTE:
The machine remains ready for brewing
and maintains a constant heating
temperature whilst the Power On/o
button is in the ‘On’ position. If the
temperature lowers, the heating light
will illuminate and the Thermoblock
Heating System will automatically
reheat to the correct brewing
temperature
STEP 8 – EMPTYING THE FILTER HOLDER
• Remove the Filter Holder from the Brew
Head by turning the Filter Holder to the left
until it releases. To empty the used co ee
grounds, turn the  lter holder upside down
in a bin and gently tap out the co ee (used
co ee grounds should be thrown away
with domestic waste and not down the sink
which may block drains). Remove the Filter
by using using the indents on the side of
the Filter Holder. Rinse the Filter and Filter
Holder with water and allow to dry.
16
OPERATING YOUR ESPRESSO MACHINE ES 8010