Catler ES 8010 - Operating Your Espresso Machine es 8010

OPERATING YOUR ESPRESSO MACHINE ES 8010
1313
OPERATING YOUR ESPRESSO MACHINE ES 8010
STEP 1 – FILLING THE WATER TANK
• Ensure the Power On/O button is ‘O ’
and the Selector Control is set to the ‘bbb’
Standby position.
• Turn the machine o at the power outlet
and unplug the power cord.
• Remove the Filter Holder if locked into the
Brew Head and move the Steam Wand to
the side of the machine.
• Remove the Water Tank by pulling with the
handle insert in the front of the Espresso
Machine.
• When the Water Tank is removed, a black
tube slides and extends out from the Water
Tank storage area. Do not touch or try to
remove this tube, it will automatically slide
back into position when the Water Tank is
reinserted.
• Fill the Water Tank with cold water to the
maximum mark on the Water Window and
slide the Water Tank carefully back into
position in the machine.
NOTE:
Check the water level before use and
replace the water daily.
The water tank should be re lled with
fresh cold water before each use.
Do not use mineral or distilled water or
any other liquid.