STEAM BUTTON/HOT WATER BUTTON
• The Steam button surround will
automatically illuminate after the machine
has rst reached the correct temperature.
• The machine will always automatically
default to the Steam button when the
appliance is rst switched on.
• Both buttons cannot be operated at the
same time.
• To select steam: when the Steam button
surround is illuminated, just set the
Selector Control to ‘Steam’
• To select hot water: press the Hot Water
button and the surround will illuminate,
then just set the Selector Control
to ‘Steam’ .
• If the machine remains switched ‘On’, the
last button function used (Steam or Hot
Water) will stay illuminated.
NOTE:
Always ensure that the Frothing
Attachment has been rmly pushed
onto the Steam Wand and connects
with the rubber surround.
For best results use cold fresh milk (low
fat milk will froth easier)
Always clean the Steam Wand and
Frothing Attachment after every use.
Refer to Care and Cleaning on Page 25.
NOTE:
For brewing more co ee immediately
after using the steam function,
the Espresso Machine features an
auto-purge function. This ensures
that ground co ee will not be burnt
by the initial water ow from the
thermoblock that could be too hot.
Instead this water is automatically
released internally into the Drip Tray
ensuring that the internal thermostat is
at optimal temperature for extracting
co ee. Your co ee will always be
extracted at this optimal temperature
ensuring only the best avoured co ee
is achieved.
1919
HOW TO FROTH MILK FOR A CAPPUCCINO OR LATTÉ
WARNING:
MILK SHOULD NOT BE ALLOWED TO RUN OVER THE TOP OF THE FROTHING
ATTACHMENT, OTHERWISE IT WILL NOT FUNCTION PROPERLY.
TO AVOID SPLATTERING OF HOT MILK, DO NOT LIFT THE END OF THE FROTHING
ATTACHMENT ABOVE THE SURFACE OF THE MILK WHILE FROTHING.
ENSURE THE SELECTOR CONTROL IS IN THE ‘STANDBY’ POSITION BEFORE REMOVING THE
FROTHING JUG.
To Next Page
