Electrical Information
IMPORTANT – ONLY USE A 3 AMP FUSE
The use of a 13A fuse can cause internal wiring damage which will not
be covered under the CDA warranty.
Do not mount the electrical isolation switch behind the chimney section.
It is a requirement that you must be able to isolate the extractor from
the mains electrical supply after installation.
Rated voltage (mains electrical voltage): 230 – 240Vac, 50Hz
Rated input (rated power consumption): 95W
Motor input: 90W
Lam
p power: 1 x 5W
Troubleshooting
If your extractor is not working
1. Check that the mains electrical supply has not been switched o.
2. Check that the fuse in the spur has not blown.
3. Contact CDA Customer Care.
Instruction Manual | 13
To Next Page
Loading...
