CDA CST61SS User Manual

11
Installation
When the extractor is to be installed above an electric hob, the
minimum distance between the hob and extractor must exceed
600mm (650mm is recommended).
When the extractor is to be installed above a gas hob, the minimum
distance between the hob and extractor must exceed 700mm
(750mm is recommended).
If the instructions provided with your gas hob state that the required
distance between the hob and extractor must be greater than
700mm, then that is the distance that should be observed; this is a
legal requirement and may lead to your hob being disconnected from
the gas supply and the installation being reported under RIDDOR (the
height should be measured from the top of the burners).
IN THE ABSENCE OF ANY INSTRUCTIONS SUPPLIED WITH THE
GAS HOB, THE MINIMUM DISTANCE BETWEEN THE HOB AND
EXTRACTOR MUST BE AT LEAST
760mm.
The width of any hob must not be
greater than the width of the extractor
installed above it.
Fig. 3
Gas: 750mm recommended
Electric: 650mm recommended

CDA CST61SS Specifications

General

Brand	CDA
Model	CST61SS
Category	Ventilation Hood
Language	English