7
To remove the grease filter
• Open the grease filter cover by sliding the retaining clips across.
• Remove the wire filter clip then lift out the grease filter itself (shown
as “G” in figure 2).
To replace the grease filter
• Repeat the steps above in reverse.
Please note: Cleaning the filter in the dishwasher may lead to
discolouration. This is normal and does not constitute a fault with the
appliance.
Changing the charcoal filter (re-circulating only)
(Charcoal filter - CDA part number: CHA36)
To ensure best performance of your extractor, you should replace the
charcoal filter every four to six months, depending on use. See page
14 for information on how to fit a new filter.
Fig. 2
To Next Page
Loading...
