CDA ECHK90 User Manual

8
Changing the light
Mounting your extractor
If the instructions provided with your gas hob state that the required
distance between the hob and extractor must be greater than
700mm, then that is the distance that should be observed; this is a
legal requirement and may lead to your hob being disconnected from
the gas supply and the installation being reported under RIDDOR (The
height should be measured from the top of the burners).
IN THE ABSENCE OF ANY INSTRUCTIONS SUPPLIED WITH THE
GAS HOB, THE MINIMUM DISTANCE BETWEEN THE HOB AND
EXTRACTOR MUST BE AT LEAST 760mm.
Replaceable (LED only) light
source by a professional
LED LED
In case of malfunction of the illumination system contact the
technical service.
When the extractor is to be installed above an electric hob, the
minimum distance between the hob and extractor must exceed 600mm
for ceramic and solid plate hobs and 550mm for induction Hobs.
When the extractor is to be installed above a gas hob, the minimum
distance between the hob and extractor must exceed 650mm.

CDA ECHK90 Specifications

General

Brand	CDA
Model	ECHK90
Category	Ventilation Hood
Language	English