CDA EVPC9 User Manual

Mounting your Extractor
When the extractor is to be installed above hob, the minimum
distance between the hob and extractor must exceed 650mm.
If the instructions provided with your gas hob state that the
required distance between the hob and extractor must be
greater than 650mm, then that is the distance that should be
observed; this is a legal requirement and may lead to your hob
being disconnected from the gas supply and the installation
being reported to RIDDOR (The height should be measured
from the top of the burners).
IN THE ABSENCE OF ANY INSTRUCTIONS SUPPLIED
WITH THE GAS HOB, THE MINIMUM DISTANCE
BETWEEN THE HOB AND EXTRACTOR MUST BE AT
LEAST 760mm.
The width of any hob must not be greater than the width of
the extractor installed above it. Fig. 5
Ducting and Ventilation
For best performance and lowest noise output, we
recommend the use of 125mm or 150mm ducting. You can
also use 100mm ducting but this will reduce performance.
Fig. 5
7
650mm recommended

CDA EVPC9 Specifications

General

Brand	CDA
Model	EVPC9
Category	Ventilation Hood
Language	English