14
Use of the key lock when the hob is in use
The key lock LED is illuminated to confirm the key lock is switched on
and no adjustments can be made to any of the zones or the timer.
It is possible to switch o the hob using the On/O key when the
key lock is on, for safety reasons.
Residual heat indicators
The hob is equipped with residual heat indicators to warn when any
of the zones are still hot to the touch after cooking. An “H” will show
in the relevant zone display after cooking until the zone is at a safe
temperature to touch.
In the event of a power cut, the residual heat indictors will illuminate
after the power supply is restored. However, when there is no power
supply to the hob the residual heat indicators will not work, so extra
care must be taken.
Please note:
You should avoid touching the zones when the hob is in use, or when
an “H” is showing on the zone display.
Small object safety
Anything left on the control panel (e.g. cutlery or towels) will cause
the hob to switch o automatically and there will be a beep every ten
seconds until the obstruction is removed.
Pan detection
The hob is equipped with a sensor that will advise when the pan is
To Next Page
Loading...
Need help?
General
