What to do if my CDA hob does not work and no indicators are lit?
If your CDA hob isn't working and no indicators are lit, it could be due to the hob not being connected to the power supply or a faulty power supply. Check the electrical circuit, replace it if necessary, and ensure the appliance is turned on.
How to fix one or multiple zones that do not work on my CDA hob?
If one or more zones on your CDA hob aren't working, the internal electronics may be faulty and need a reset. Disconnect the hob from the mains for a few minutes to reset it.
Why does my CDA HN3615FR keep switching itself off?
Your CDA hob might be switching off because no heat level was set within 10 seconds of turning it on, or the sensor fields are covered or dirty. Try switching on the appliance and setting a zone and heat setting without delay. Also, ensure the sensor fields are uncovered and clean.
What to do if my CDA HN3615FR Hob is not working and the display shows a non-standard graphic?
If your CDA hob is not working and the display shows a non-standard graphic, it could be because a sensor field was touched too briefly. Try touching the sensor field again, but this time for a longer duration.
Why does a cooking zone on my CDA HN3615FR Hob switch off and show a residual heat indicator?
A cooking zone on your CDA hob might switch off and show a residual heat indicator because the operating time limiter has activated, sensor fields are covered or dirty, or electronic components have overheated. Uncover or clean the sensor fields and allow the appliance to cool.
Why are the sensor fields on my CDA hob not responding?
The sensor fields on your CDA hob might not be responding because the safety key lock is activated, multiple sensors are being touched simultaneously, or there is dirt or residue on the sensors. Try switching off the safety key lock, touching only one sensor at a time, and carefully cleaning the sensors.
What does it mean if my CDA HN3615FR doesn't respond and beeps continuously?
If your CDA hob doesn't respond and emits an extended beep, it indicates improper use, such as touching the wrong sensor fields or touching them too briefly. Switch the appliance off via the on/off sensor and at the mains, then switch the power and appliance on again.
Why is my CDA HN3615FR making a buzzing noise?
Your CDA hob may be making a buzzing noise because the cookware you're using isn't suitable for induction, or if multiple cooking zones are used simultaneously, the hob can make hissing noises.
What does it mean if my CDA HN3615FR stopped and shows E2, ER21 or ER40?
If your CDA hob has stopped operating and displays E2, ER21, or ER40, it indicates that the electronics have overheated. Stop using the appliance immediately and switch it off at the mains.
What to do for over-temperature at the induction temperature sensor (E5) on my CDA HN3615FR?
Restart the CDA hob after it has been given time to cool down.
General| Type | Gas Hob |
|---|---|
| Number of Burners | 4 |
| Fuel Type | Gas |
| Material | Stainless Steel |
| Ignition Type | Automatic |
| Safety Features | Flame Failure Safety Device |
To Next Page
