11
Safety key lock
The hob is equipped with a safety key lock that helps to prevent
accidental or inadvertent activation of the hob.
To activate the safety key lock
• Simply touch the “lock sensor” (8). The timer display will show “Lo”
to confirm that the lock has been activated successfully. This can be
done with the hob running or in standby mode.
To deactivate the safety key lock
• Simply touch and hold the “lock sensor” (8) for approximately three
seconds. The timer display will show dashes or the remaining time
to confirm that the lock has been deactivated successfully.
Please note: The safety key lock will deactivate if the hob
disconnected from the mains.
Residual heat indicators
Residual heat indicators warn when any of the zones are still hot
to the touch after use. An “ ” will show in a zone’s indicator if the
relevant zone is above approximately 45°c. Avoid touching any zone
whilst the hob is in use or whilst a residual heat indicator is displayed.
In the event of a power cut or failure, the residual heat indicators will
not illuminate after the power supply is restored. Also, when there is
no power supply to the hob the residual heat indicators will not work,
yet the hob zone(s) may still be hot, so extra care must be taken.
To Next Page
Loading...
