What to do if my CDA hob is not working and the lights on the control panel do not switch on?
If your CDA hob isn't working and the control panel lights are off, the hob might not be connected to the power supply, or the power supply could be faulty. Check the electrical circuit breaker and fuses.
What to do if my CDA hob has stopped operating, beeps and ER03 is displayed on the zone display?
If your CDA hob has stopped, beeps, and shows ER03, it means there was an overflow or an object is in contact with the control panel. Clean the hob or remove the object, and begin cooking again.
Why has my CDA hn9625 stopped operating and the display shows E2, ER21 or ER40?
If your CDA hob has stopped and shows E2, ER21, or ER40, the electronics have overheated. Allow the hob to cool down. Check the Installation section to ensure the ventilation requirements have been met.
What to do if my CDA hn9625 Hob installation blows a fuse or only one side of the hob works?
If your CDA hob installation blows a fuse or only one side works, the electrical connection of the hob is incorrect. Check that it is set up properly according to the Electrical Connection section.
Why after turning on a zone, does the zone display show cookware not suitable for induction on my CDA hn9625 Hob?
If, after turning on a zone, the zone display shows cookware not suitable for induction, it means the cookware you're using isn't suitable for induction, or it's less than 11cm on the 160mm zones, or 145mm on the 200mm zones.
What to do if my CDA hob is not working and the display shows a non-standard graphic?
If your CDA hob isn't working and the display shows a non-standard graphic, the electronics are not functioning. Call CDA Customer Care.
How to get rid of the odour during the first cooking sessions on my CDA hn9625 Hob?
To eliminate the odor during the initial cooking sessions with your CDA hob, heat a saucepan full of water on each cooking zone for 30 minutes.
Notes on safe use, including hot surfaces and child safety.
Information for users with heart pacemakers or active implants.
Crucial safety reminders regarding hob damage and electrical hazards.
Methods to check if cookware is compatible with induction hobs.
Identification and function of hob controls and displays.
Procedure for turning the hob on, off, and switching zones.
Immediate actions required in case of hob glass damage.
Mandatory earthing of the appliance for safety.
Guidance on connecting to fixed wiring via a double pole switch.
Details on mains cable specifications and appliance power rating.
To Next Page
General
